Start your Corolla. Close all windows and doors. Open the window by pressing and holding the window control switch. When the window is fully open, keep the switch pressed for a few seconds. Release the switch, then press it again and hold it for a few seconds. Close the window by lifting and holding the window control switch. This has to be either the window motor, wiring or the linkage. If you don't hear anything when you do the switch it could be the motor or it could be the wiring to the motor. Get a meter or a power probe and see if there is 12v there when you do the switch. Some other good troubleshooting advice above from Avisitor. According to online references for the 2016 Grand Caravan, 68298870AA is the non-power rear window master switch and 68298871AA is the power rear window master switch. 2009 Dodge Grand Caravan SE Stow 'n Go 3.3L - ~190,000 km (~118,000 mi) Bright Silver Metallic, Dark Slate/Light Shale. Options: Power Window Group. 1. Disconnect all affected components (exterior mirror, pressure temperature sensor, door switch block, control unit). 2. Carry out a line check. 3. Reconnect the control unit; delete fault memory; carry out terminal change; read out fault memory. Replace the control unit if a short circuit is detected. 4. The presence of obstruction. The latch lacking lube. A dead switch. Loose or disconnected linkages. Actuator wire, fuse, gear, and motor issues. With that said, it’s essential to determine whether all or just the driver’s side door lock not working to help you check the specific issue, so we’ll look into those. Vay Tiền Trả Góp 24 Tháng.

power window switch not working